Publicaciones en colaboración con investigadores/as de CellMat Technologies S.L. (7)

2021

  1. Effect of the elastomer viscosity on the morphology and impact behavior of injection molded foams based on blends of polypropylene and polyolefin elastomers

    Journal of Applied Polymer Science, Vol. 138, Núm. 20

  2. Effect on the Impact Properties of Adding Long-Chain Branched Polypropylene in Polypropylene-Polyolefin Elastomer Cellular Polymers Produced by Core-Back Injection Molding

    Macromolecular Materials and Engineering, Vol. 306, Núm. 4

2020

  1. Effect of gas-phase tortuosity on the mechanical properties of low-density polyolefin open-cell foams at low- and high-strain rates

    Journal of Applied Polymer Science, Vol. 137, Núm. 11

  2. Foams with enhanced ductility and impact behavior based on polypropylene composites

    Polymers, Vol. 12, Núm. 4

2019

  1. Crosslinked ethylene butyl acrylate copolymer foams with different cellular structure interconnectivity and tortuosity: Microstructure and physical properties

    Journal of Applied Polymer Science, Vol. 136, Núm. 45

  2. Effect of mold temperature on the impact behavior and morphology of injection molded foams based on polypropylene polyethylene-octene copolymer blends

    Polymers, Vol. 11, Núm. 5

2017

  1. Low density open cell flexible foams with high tortuosities and mechanical properties highly dependent on the strain rate

    Annual Technical Conference - ANTEC, Conference Proceedings